Quickly getting started with NodeMCU / ESP8266 12E for Beginner

This is a short, easy, beginner friendly tutorial on how to get setup with the NodeMCU. I tell you a little bit about the NodeMCU, then I show you how to very quickly set it up. I show you how to set up the Arduino Software and I go through how to get the blink sketch working – In 7 minutes! The NodeMCU is basically an ESP8266 mounted on a break out board.

via YouTube https://youtu.be/NEo1WsT5T7s

Leave a Comment

Your email address will not be published. Required fields are marked *